Blacksmith Forge Stove Spares

A High Grade Cast Iron Replacement Baffle/Throat Plate to fit theBlacksmith Forge Stove. This is the lower baffle on the Forge which sits between the carrier frame and the boiler at the lower rear of the stove.

Remove the fire fence and lift up and tilt out the baffle plate to remove.

Baffle plates should be checked every couple of months of use to ensure that there is no build up of soot sitting above it. Damaged or warped baffles will give a reduced efficiency and heat from the stove.

A set of 2 side bricks made from high density vermiculite insulation bricks for the popular Blacksmith Forge stove. Remove the fire fence and top baffle to replace any existing bricks that need replaced.

Fire bricks only need replacing if damage to them begins to expose the stove's bodywork to flames. In severe cases of prolonged exposure this could permanently damage the stove by cracking a cast iron side panel or warping the bodywork.

Please check the shape of your bricks before you buy as earlier models of the Blacksmith Forge Non Boiler Stove had non-shaped square bricks as the side bricks.

This is the back brick for the Blacksmith Forge Stove made from high density vermiculite insulation brick.

Fire bricks only need replacing if damage to them begins to expose the stove's bodywork to flames. In severe cases of prolonged exposure this could permanently damage the stove by cracking a cast iron side panel or warping the steel bodywork.

These are the front bricks which sit under the fire fence of the Best Selling Blacksmith Forge Stove boiler and non-boiler. Remove the fire fence and the L Bracket and Screw before removing.

A full set of high density vermiculite insulation bricks for the popular Blacksmith Forge stove. Remove the fire fence and top baffle to replace any existing bricks that need replaced.

Fire bricks only need replacing if damage to them begins to expose the stove's bodywork to flames. In severe cases of prolonged exposure this could permanently damage the stove by cracking a cast iron side panel or warping the steel bodywork.

This set includes the 2 side bricks, the one piece back brick strip and the the two front bricks which sit under the fire fence on the Blacksmith Forge Non-Boiler Stove.

Please check the shape of your bricks before you buy as earlier models of the Blacksmith Forge Non Boiler Stove had non-shaped square bricks as the side bricks.

A single piece high grade cast iron fire fence bar to fit the Blacksmith Forge Stove. The Fire Fence or log retainer keep logs from falling out when the door is open and you need to add fuel.