Morso 4055

Side Firebrick suitable for Morso S10 and 4155 Series Stove. Bricks are not handed, but are sold individually. Aftermarket Part.

Rear Firebrick for Morso S10 and 4155 Series Stove. Sold Individually. Aftermarket Part.

Lower Baffle Brick suitable for Morso S10 and 4155 Series Stoves. The lower baffle brick rests on top of the side firebricks. Sold Individually. Aftermarket Part.

Upper Baffle Brick for Morso S10 and 4155 Series Stoves. Sold Individually. This baffle brick sits above the lower baffle. Aftermarket Part

Grate for Morso S10, 4000 and 4100 Series Stove. Sold Individually

A 400ml can of high temperature Morso Spray Paint for re-spraying your Morso Stove. Defined as Dark Grey but also known as original Black. Matt finish.

Fire Rope Kit

Fire Rope is used to form an air tight seal between the stove door and the stove body to maximise the efficiency and heat output of the stove. A poor seal will allow for additional air to get into the stove fire box increasing the rate of fuel burn and reduce control over the fire burn rate. Rope thickness will vary according to the manufacturer and the size of the stove. Fire Rope is held in place by a High Temperature Rope Adhesive.

Rope Kit contains: 2.5m Fire Rope + Rope End + High Temperature Rope Adhesive.

This SiS Glass Clip & Screw is suitable for a variety of Morso stoves.

Clip Length: 20mm
Clip Width: 9m

When purchasing this item, you will receive 1 x Glass Clip & 1 x Screw.
Please order the amount you require by changing the order quantity in the box above..
Different stoves take different kinds of clips & screws/nuts so please use the images & measurements above to determine whether these will be suitable for your stove.

Please make sure when replacing your clips that you also replace the rope seal around the glass at the same time. Failure to do this could result in your glass cracking.
Also take care not to over tighten the screw as this can also crack the glass. A way to lower the risk of overtightening is to firstly tighten the screw by hand so you can check the tension and then tighten it further

This SiS Glass Clip & Screw is suitable for a variety of Morso stoves.

Clip Length: 27mm
Clip Width: 9m

When purchasing this item, you will receive 1x Glass Clip & 1x Screw.

Order the amount you require by changing the order quantity in the box above

Different stoves take different kinds of clips & screws/nuts so please use the image & measurements above to determine whether these will be suitable for your stove.

Please make sure when replacing your clips that you also replace the rope seal around the glass at the same time. Failure to do this could result in your glass cracking

Also, take care not to over tighten the screw as this can crack the glass.
A way to lower the risk of overtightening is to first tighten the screw by hand so you can check the tension and then tighten it further